To run label calibration for an Arkscan label printer using the two-hand method:
1. Ensure the label rolls are properly aligned. Before calibration, about half an inch of the label should be sticking out of the printer.
2. Turn off the printer by pressing the left side of the power switch.
3. Press and hold the green button on top of the printer while simultaneously turning the printer on.
4. Release the green button immediately when the printer beeps or flashes red.
5. If calibration is successful, two blank labels should be pushed out, and the perforated line should align with the printer's edge. The printer is then ready to print.
A Detailed Instructions can be found in YouTube tutorial below:
